Storing A Line Card; Figure 78: Do Not Rest The Edge Of A Line Card On A Hard Surface - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide

Storing a Line Card

234

Figure 78: Do Not Rest the Edge of a Line Card on a Hard Surface

If you must rest a line card temporarily on an edge, place a cushion between
the edge and the surface.
Do not stack line cards on top of one another or on top of any other
component. Place each line card separately in an antistatic bag or on an
antistatic mat placed on a flat, stable surface.
You must store a line card in the chassis or in a spare shipping container, horizontally and
sheet metal side down. Do not stack line cards on top of one another or on top of any
other component. Place each line card separately in an antistatic bag or on an antistatic
mat placed on a flat, stable surface.
NOTE: Because a line card is heavy, and because antistatic bags are fragile,
inserting the line card into the bag is best done with two people, each to do
one of the following steps.
To insert a line card into an antistatic bag:
Hold the line card in the horizontal position with the faceplate facing you.
1.
Slide the opening of the bag over the line card connector edge.
2.
Copyright © 2015, Juniper Networks, Inc.