Troubleshooting Line Cards In Ex9200 Switches - Juniper EX9214 Hardware Manual

Related
Documentation

Troubleshooting Line Cards in EX9200 Switches

Problem
Solution
Copyright © 2015, Juniper Networks, Inc.
Verify that the AC power cord or DC power cables from the power source to the switch
are not damaged. If the insulation is cracked or broken, immediately replace the cord
or cable.
Connect the power supply to a different power source with a new power cord or power
cables. If the power supply status LEDs indicate that the power supply is not operating
normally, the power supply is the source of the problem. Replace the power supply
with a spare.
EX9204 Switch Hardware Overview
EX9208 Switch Hardware Overview
EX9214 Switch Hardware Overview on page 3
Description: Line card is not functioning normally.
Monitor the LED labeled
operating switch.
The Routing Engine downloads the line card software to it under two conditions: the
line card is present when the Routing Engine boots Junos OS, and the line card is
installed and requested online through the CLI or the button on the front panel. The
line card then runs diagnostics, during which the
online and functioning normally, the
Make sure the line card is properly seated in the midplane. Check that each ejector
handle has been turned clockwise and is tight.
Check the OK/FAIL LED on the line card and
interface. When the line card is online and functioning normally, the
steadily.
Issue the
show chassis fpc
shown in the sample output, the value
that the line card is functioning normally:
user@switch> show chassis fpc
Temp
Slot State
0 Online
1 Online
2 Online
3 Online
4 Online
5 Online
NOTE: The show chassis fpc
OK on the craft interface as soon as a line card is seated in an
OK
LED is lit green steadily.
OK
OK and
command to check the status of installed line cards. As
Online in the column labeled
CPU Utilization (%)
(C) Total Interrupt
30 8 0
30 9 0
30 7 0
30 10 0
30 9 0
31 10 0
command displays the status of the line cards.
Chapter 27: Troubleshooting Procedures
LED blinks. When the line card is
FAIL line card LEDs on the craft
LED is lit green
OK
State indicates
Memory Utilization (%)
DRAM (MB) Heap Buffer
2048 24
2048 14
2048 14
2048 14
2048 15
2048 15
14
14
14
14
14
14
259