S2200 Sas Controller Module-Rear Panel Leds - Lenovo S3200 Setup Manual

S2200 SAS controller module—rear panel LEDs
12Gb/s
LINK
SAS 0 SAS 1
ACT
LED Description
1 Host 12 Gb SAS,
Link Status
2 Host 12 Gb SAS
Link Activity
3 Network Port Link
Active Status
4 Network Port Link Speed
5 OK to Remove
6 Unit Locator
7 CRU OK
8 Fault/Service Required
9 Cache Status
10 Expansion Port Status
1
Cables must be qualified HD mini-SAS host cable options.
2
Use a qualified SFF-8644 to SFF-8644 cable option when connecting the S2200 SAS controller to a 12 Gb SAS HBA.
3
Use a qualified SFF-8644 to SFF-8088 cable option when connecting the S2200 SAS controller to a 6 Gb SAS HBA.
4
When port is down, both LEDs are off.
NOTE: Once a Link Status LED is lit, it remains so, even if the controller is shut down via the SMC or the CLI.
68 LED descriptions
1
LINK
SERVICE−2
ACT CLI
2
Definition
1-3
Off — No link detected.
Green — The port is connected and the link is up.
1-3
Off — The link is idle.
Blinking green — The link has I/O activity.
Off — The Ethernet link is not established, or the link is down.
4
Green — The Ethernet link is up (applies to all negotiated link speeds).
4
Off — Link is up at 10/100base-T negotiated speeds.
Amber — Link is up and negotiated at 1000base-T.
Off — The controller module is not prepared for removal.
Blue — The controller module is prepared for removal.
Off — Normal operation.
Blinking white — Physically identifies the controller module.
Off — Controller module is not OK.
Blinking green — System is booting.
Green — Controller module is operating normally.
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled power-up or a cache flush or restore
error.
Green — Cache is dirty (contains unwritten data) and operation is normal.
The unwritten information can be log or debug data that remains in the
cache, so a Green cache status LED does not, by itself, indicate that any user
data is at risk or that any action is necessary.
Off — In a working controller, cache is clean (contains no unwritten data).
This is an occasional condition that occurs while the system is booting.
Blinking green — A CompactFlash flush or cache self-refresh is in progress,
indicating cache activity.
See also
Off — The port is empty or the link is down.
On — The port is connected and the link is up.
Figure 44 LEDs: S2200 SAS controller module (HD mini-SAS)
5
CLI ACT LINK SERVICE−1
3 4 6
Cache Status LED details on page 69.
7
6Gb/s
CACHE
8 9 10