Components; Front Panel Components; 24-Drive Enclosure Front Panel Components - Lenovo S3200 Setup Manual

1

Components

Front panel components

Lenovo Storage S3200/S2200 supports 2U24 and 2U12 enclosures in dual-purpose fashion. The 2U24
chassis—configured with 24 2.5" small form factor (SFF) disks—is used as either a controller enclosure or
expansion enclosure. The 2U12 chassis—configured with 12 3.5" large form factor (LFF) disks—is also
used as either a controller enclosure or expansion enclosure.
Supported expansion enclosures are used for adding storage. The E1012 12-drive enclosure is the LFF drive
enclosure used for storage expansion. The E1024 24-drive enclosure is the SFF drive enclosures used for
storage expansion (also see
Enclosures support single or dual I/O modules (IOMs), and can be equipped with either two redundant AC
or two redundant DC power supply modules (see
NOTE: The term IOM can refer to either a RAID canister or an expansion canister.

24-drive enclosure front panel components

The geometric representation of 2U24 front panel components is identical for S2200 and S3200.
Note: Remove this enclosure bezel to access the front panel components shown below.
Left ear
0 1
1
Note: Integers on disks indicate drive slot numbering sequence.
1 Enclosure ID LED
2 Disk drive status LED: Power/Activity
3 Disk drive status LED: Fault
4 2.5" disk or drive blank (typical 24 slots)
Table 4 on page 24).
2 3 4 5 6 7
2 3
Figure 1 2U24 enclosure: front panel
Controller enclosure — rear panel layout
8 9 10 1 1 12 13 14 15
4
5 Enclosure status LED: Unit Locator
6 Enclosure status LED: Fault/Service Required
7 Enclosure status LED: CRU OK
8 Enclosure status LED: Temperature Fault
Lenovo Storage S3200/S2200 Setup Guide
on page 15).
5
6
7
8
16 17 18 19 20 21 22
5
5
6
6
7 7
OK
8 8
(Silk screens on bezel)
OK
Right ear
23
13