Download Print this page

Advertisement

Disk drive LEDs

You must remove the enclosure bezel to facilitate visual observation of disk LEDs. Alternatively, you can use
management interfaces to monitor disk LED behavior.
2
1
LED No./Description
1— Power/Activity
2— Fault
For information about disk drive types supported in S3200/S2200 LFF and SFF disk drive modules, see
Disk drives used in S3200/S2200 enclosures
For information about replacing a disk drive module in an S3200/S2200 controller enclosure or an
E1024/E1012 drive enclosure, see the "Replacing a disk drive module" topic in the CRU Installation and
Replacement Guide.
For information about creating a disk groups, see the "Provisioning the system" topic within the Storage
Manager Guide.
IMPORTANT: For information about self-encrypting disk (SED) drives, see
and the Storage Management Guide or online help.
NOTE: Additional information pertaining to disk drive LED behavior is provided in the supplementary
tables on the following page.
60
LED descriptions
3.5" LFF disk drive module
(see table below)
Color
State
Green
On
Blink
Off
Amber
On
Blink
Off
Blue
Blink
Figure 37 LEDs: Disk drive modules
on page 15.
2.5" SFF disk drive module
(see table below)
Definition
The disk drive module is operating normally.
The disk drive module is initializing; active and processing
I/O; performing a media scan; or the disk group is initializing
or reconstructing.
If not illuminated and Fault is not illuminated, the disk is not
powered on.
The disk has failed; experienced a fault; is a leftover; or the
disk group that it is associated with is down or critical.
Physically identifies the disk; or locates a leftover (also see Blue).
If not illuminated and Power/Activity is not illuminated, the disk
is not powered on.
Leftover disk from disk group is located (alternates blinking
amber).
1
2
FDE considerations
on page 21

Advertisement

Troubleshooting

   Also See for Lenovo S3200

   Related Manuals for Lenovo S3200

This manual also for:

S2200

Comments to this Manuals

Symbols: 0
Latest comments: