Download Print this page

Lenovo S3200 Setup Manual: Is The Controller Back Panel Cru Ok Led Off

Hide thumbs

Advertisement

Is the controller back panel CRU OK LED off?

Answer
No
(blinking)
Yes
Table 8 Diagnostics LED status: Rear panel "CRU OK"
Is the controller back panel Fault/Service Required LED amber?
Answer
No
Yes (blinking)
Table 9 Diagnostics LED status: Rear panel "Fault/Service Required"
Are both disk drive module LEDs off?
Answer
Yes
Table 10 Diagnostics LED status: Disk drives (LFF and SFF modules)
NOTE: See
Disk drives used in S3200/S2200 enclosures
Is the disk drive module Fault LED amber?
Answer
Yes, and the
online/activity
LED is off.
Yes, and the
online/activity
LED is blinking.
Table 1 1 Diagnostics LED status: Disk drive fault status (LFF and SFF modules)
NOTE: See
FDE considerations
50
Troubleshooting
Possible reasons
System functioning properly.
System is booting.
The controller module is not powered on.
The controller module has failed.
Possible reasons
System functioning properly.
One of the following errors
occurred:
Hardware-controlled power-up error
Cache flush error
Cache self-refresh error
Possible reasons
There is no power
The drive is offline
The drive is not configured
Possible reasons
The disk drive is offline. An event
message may have been received
for this device.
The disk drive is active, but an event
message may have been received
for this device.
on page 21 for S3200 enclosures.
Actions
No action required.
Wait for system to boot.
Check that the controller module is fully inserted
and latched in place, and that the enclosure is
powered on.
Check the event log for specific information
regarding the failure.
Actions
No action required.
Restart this controller from the other controller
using the SMC or the CLI.
If the above action does not resolve the fault,
remove the controller module and reinsert it.
If the above action does not resolve the fault,
contact Lenovo for assistance. It may be necessary
to replace the controller module.
Actions
Check that the drive is fully inserted and latched in
place, and that the enclosure is powered on.
on page 15.
Actions
Check the event log for specific information regarding
the fault.
Isolate the fault.
Contact Lenovo for assistance.
Check the event log for specific information regarding
the fault.
Isolate the fault.
Contact Lenovo for assistance.

Advertisement

   Also See for Lenovo S3200

This manual also for:

S2200

Comments to this Manuals

Symbols: 0
Latest comments: