Download Print this page

Lenovo S3200 Setup Manual: Terminal Emulator Display Settings; Terminal Emulator Connection Settings; Connecting A Usb Cable To The Cli Port

Hide thumbs

Advertisement

Connect USB cable to CLI
port on controller face plate
3. Enable the CLI port for subsequent communication:
• Linux customers should enter the command syntax provided in
driver
on page 79.
• Windows customers should locate the downloaded device driver described in
software download
4. Start and configure a terminal emulator, such as HyperTerminal or VT- 1 00, using the display settings in
Table 5
and the connection settings in
Table 5 Terminal emulator display settings
Parameter
Terminal emulation mode
Font
Translations
Columns
Table 6 Terminal emulator connection settings
Parameter
Connector
Baud rate
Data bits
Parity
Stop bits
Flow control
1
Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2
Verify the appropriate COM port for use with the CLI.
5. In the terminal emulator, connect to controller A.
6. Press Enter to display the CLI prompt (#).
The CLI displays the system version, MC version, and login prompt:
a. At the login prompt, enter the default user manage.
b. Enter the default password
If the default user or password—or both—have been changed for security reasons, enter the secure
login credentials instead of the defaults shown above.
42
Connecting hosts
Figure 30 Connecting a USB cable to the CLI port
on page 78, and follow the instructions provided for proper installation.
Table 6
(also, see the note following this procedure).
Value
VT- 1 00 or ANSI (for color support)
Terminal
None
80
Value
COM3 (for example)
1 15,200
8
None
1
None
manage.
!
Setting parameters for the device
1,2
Obtaining the

Advertisement

Troubleshooting

   Also See for Lenovo S3200

   Related Manuals for Lenovo S3200

This manual also for:

S2200

Comments to this Manuals

Symbols: 0
Latest comments: