Operator's Panel Leds (2U Enclosures) - Lenovo Storage D1212 Hardware Installation And Maintenance Manual

Figure 57. 2.5" Drive Carrier LEDs
Table 12. Drive LED States
Green Drive LED
Off
On/Flashing
On
On
Off
On

Operator's Panel LEDs (2U Enclosures)

The Ops panel ( "Operator's (Ops) Panel (2U Enclosures)" on page 17) displays the aggregated status of all
the modules. The Ops panel LEDs are defined in the following table.
Table 13. Ops Panel LED States
Module
System Power
(Green/Amber) Fault
(Amber)
On Off
On On
Amber Drive LED
Off
Off
Flashing: 1 second on / 1 second off
On
On
Flashing: 1 second on / 1 second off
Location LED
Associated LEDs/
(Blue) (not Dis- Alarms
used) play
X
X
On
Status
No drive installed
Drive installed and operational
SES device identity set
SES device fault bit set
Power control circuit failure
RAID array status
The events in which the RAID
controller can set this notification are:
• Array rebuild in progress
• Array consistency check
• Do not remove device
• Disk in failed Array
• Aborted array rebuild
Status
5V standby power present, overall
power failed or switched off
Ops panel power on (blinks 3 times),
test state
.
Chapter 5 Troubleshooting and Problem Solving
55