Download Print this page

Lenovo S3200 Setup Manual: Summary Of Drive Enclosure Cabling Illustrations

Hide thumbs

Advertisement

Summary of drive enclosure cabling illustrations

The following illustrations show both reverse and straight-through cabling examples featuring
S3200/S2200 controller enclosures and compatible E1024 (2U24), and E1012 (2U12) drive enclosures.
The rear-panel views of the E1024 and E1012 are identical. All storage enclosures use mini-SAS connectors
for expansion.
NOTE: The S3200/S2200 controller enclosures and compatible drive enclosures support 6 Gb SFF-8088
mini-SAS connectors for adding storage. See
NOTE: For clarity, the schematic diagrams show only relevant details such as face plate outlines and
expansion ports. For detailed illustrations, see
see the controller module face plate illustrations that follow the rear panel layout.
0A
0B
1A
1B
Enclosures equipped with single IOM
Figure 12 Cabling connections between a controller enclosure and one 2U drive enclosure
The figures above show examples of an S3200 or S2200 controller enclosure cabled to a single drive
enclosure. Supported drive enclosures are ordered separately.
NOTE: The E1024 and E1012 drive enclosures can be configured with single or dual expansion canisters.
Within
Figure
empty IOM slot in each of the enclosures is covered with an IOM blank to ensure sufficient air flow during
enclosure operation. The illustration on the right shows cabling of enclosures equipped with dual IOMs.
The remaining illustrations in the section feature enclosures equipped with dual IOMs.
IMPORTANT: If the S3200/S2200 controller enclosure is configured with a single controller module, it
must be installed in the upper slot, and an I/O module blank must be installed in the lower slot (shown
above). This configuration is required to allow sufficient air flow through the enclosure during operation.
See the "Replacing a controller or expansion module" topic within the Lenovo CRU Installation and
Replacement Guide for additional information.
Controller A
IOM blank
In
Out
IOM blank
12, the illustration on the left shows cabling of enclosures equipped with a single IOM. The
Table 4
for SAS cable requirements.
Controller enclosure — rear panel layout
Controller
enclosure
0
Drive
enclosure
1
Enclosures equipped with dual IOMs
Lenovo Storage S3200/S2200 Setup Guide
on page 15. Also
Controller A
Controller B
In
Out
In
Out
0A
0B
1A
1B
25

Advertisement

Troubleshooting

   Also See for Lenovo S3200

   Related Manuals for Lenovo S3200

This manual also for:

S2200

Comments to this Manuals

Symbols: 0
Latest comments: