Download Print this page

Lenovo S3200 Setup Manual: Esfp Option For Cnc Ports; Locate The Sfp Transceivers; Install An Sfp Transceiver; Install A Qualified Sfp Option Into An S3200 Cnc Controller Module

Hide thumbs

Advertisement

E
SFP option for CNC ports

Locate the SFP transceivers

Locate the qualified SFP options for your CNC controller module within your product ship kit. The SFP
transceiver (SFP) should look similar to the generic SFP shown in the figures below.
Controller module face plate
Align SFP for installation
(plug removed/actuator open)
Controller module face plate
Align SFP for installation
(plug removed/actuator open)

Install an SFP transceiver

For each target CNC port, perform the following procedure to install an SFP. Refer to the appropriate figure
above when performing the steps. Follow the guidelines provided in
an SFP.
80
SFP option for CNC ports
Target CNC port
Figure 49 Install a qualified SFP option into an S3200 CNC controller module
Target CNC port
Figure 50 Install a qualified SFP option into an S2200 CNC controller module
Fibre-optic interface cable
Fibre-optic interface cable
Electrostatic discharge
Installed SFP
(actuator closed)
Installed SFP
(actuator closed)
when installing

Advertisement

Troubleshooting

   Also See for Lenovo S3200

   Related Manuals for Lenovo S3200

This manual also for:

S2200

Comments to this Manuals

Symbols: 0
Latest comments: