× Bookmark added
Page of 86
Download Table of Contents TroubleshootingTroublesh..

Lenovo S3200 Setup Manual: Leds: S2200 Cnc Controller Module (1 Gb Rj-45 Sfps)

Hide thumbs

Advertisement

1
PORT 0
PORT 1
2
= FC LEDs
LED
Description
1
Not used in example
2
Host 1 Gb iSCSI
Link Status/
Link Activity
3
Network Port Link
4
Active Status
4
Network Port Link Speed
5
OK to Remove
6
Unit Locator
7
CRU OK
8
Fault/Service Required
9
Cache Status
10
Expansion Port Status
1
When in FC mode, the SFPs must be a qualified 8 Gb or 16 Gb fibre optic option. A 16 Gbit/s SFP can run at 16 Gbit/s, 8 Gbit/s,
4 Gbit/s, or auto-negotiate its link speed. An 8 Gbit/s SFP can run at 8 Gbit/s, 4 Gbit/s, or auto-negotiate its link speed.
2
When in 1 GbE iSCSI mode, the SFPs must be a qualified 1 GbE iSCSI optic option.
3
When powering up and booting, iSCSI LEDs will be on/blinking momentarily, then they will switch to the mode of operation.
4
When port is down, both LEDs are off.
Figure 43 LEDs: S2200 CNC controller module (1 Gb RJ-45 SFPs)
SERVICE−2
CLI
CLI
= iSCSI LEDs
Definition
1
The FC SFP is not shown in this example (see
2,3
Off — No link detected.
Green — The port is connected and the link is up.
Blinking green — The link has I/O activity.
Off — The Ethernet link is not established, or the link is down.
Green — The Ethernet link is up (applies to all negotiated link speeds).
4
Off — Link is up at 10/100base-T negotiated speeds.
Amber — Link is up and negotiated at 1000base-T.
Off — The controller module is not prepared for removal.
Blue — The controller module is prepared for removal.
Off — Normal operation.
Blinking white — Physically identifies the controller module.
Off — Controller module is not OK.
Blinking green — System is booting.
Green — Controller module is operating normally.
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled power-up or a cache flush or restore
error.
Green — Cache is dirty (contains unwritten data) and operation is normal.
The unwritten information can be log or debug data that remains in the
cache, so a Green cache status LED does not, by itself, indicate that any user
data is at risk or that any action is necessary.
Off — In a working controller, cache is clean (contains no unwritten data).
This is an occasional condition that occurs while the system is booting.
Blinking green — A CompactFlash flush or cache self-refresh is in progress,
indicating cache activity.
See also
Cache Status LED details
Off — The port is empty or the link is down.
On — The port is connected and the link is up.
5
ACT
LINK
SERVICE−1
3
4
6
on page 69.
Lenovo Storage S3200/S2200 Setup Guide
7
6Gb/s
CACHE
8
9
10
Figure 39
on page 63).
67

Advertisement

   Also See for Lenovo S3200

This manual also for:

S2200

Comments to this Manuals

Symbols: 0
Latest comments: