Infrastructure Requirements - D-Link GLV-540 User Manual

installed and powered ON properly. If you are not able to hear any tone,
check that the power adaptor is plugged into a live electrical outlet and that
the power cord is inserted securely into the connector.
7. Now GLV-540 is ready for basic configuration as described in the section
Getting Started.
Note:
To use the wallmount feature of the phone case, reverse the Wallmount lock so
as to hold the Handset when the phone is hanged at the wall.

2.3 Infrastructure Requirements

This section describes the infrastructure requirements for proper functioning of
D-Link IP phone (GLV-540).
1. The D-Link GLV phone can work in 10/100 Mbps LAN network. Connecting the
GLV Ethernet port to a switch is recommended, this will help to provide good
quality voice communication.
2. GLV-540 phone needs a set of IP parameters for proper functioning like IP
address, Net mask, gateway address, and DNS server addresses. These
parameters can be configured statically through LCD or Web browser or even
dynamically through DHCP.
3. GLV-540 phones need a valid SIP Account to make or receive VoIP calls. IP
phone will register the assigned phone number with the SIP server on power
up. However, D-Link GLV-540 phone can initiate calls by directly dialing
destination sip URI address even without registering to SIP server.
4. If your LAN network has any firewall or NAT, then either network should
support SIP-ALG or you have to enable STUN / IP-SHARING at the GLV-540 to
make and receive calls from outside your network.
5. A TFTP / HTTP server is required to support remote software upgrade. Please
refer to software upgrade section for the upgrade procedure.
6. A PC which supports any of the following browsers for configuring the system
through web.
o
o
On Windows:
I.E version 6.0 or more
Mozilla Firefox version 1.0 or more
Mozilla version 1.7.13 or more
Netscape version 8.0.3.3 or more
On Linux:
Mozilla version 0.0.9
Galeon version 1.2.7
GLV-540 User Manual
10