D-Link GLV-540 User Manual page 55

Device Configuration : Timeouts
Maximum call duration after a call will be automatically
disconnected to avoid any misuse and unexpected lockup.
Value Range: 0 to 3600 in seconds.
Max Call
Duration
Default Value: 0
Note: Value 0 to mean that Maximum Call duration is
disabled
If GUI session is left idle for the time as configured in this
field then it will automatically log off. After this time the user
should re-login.
The following points to remembered when using this field.
Simultaneous accessing of GUI & LCD is not possible.
Web Auto Only one user can access the Phone through GUI at any
Logoff time. This applies even to logged in user with Admin
Period privilege or User privilege.
User Closing the GUI access page without Logging out,
needs to wait till this "Auto Logoff Period" to login again.
Value Range: 1 to 30 minutes.
Default Value: 10 minutes
This is the maximum time to wait for user to dial any key
after going off hook. After this timeout error tone is played
to user.
Dial Tone
Timeout Value Range: 5 to 120 Seconds
Default Value: 30 Seconds
This is the maximum time to wait to get any response from
other end after dialing out. During this period, progress tone
is played and after timeout error tone is played to user.
Progress
Timeout
Value Range: 5 to 120 Seconds
Default Value: 45 Seconds.
This is the maximum time to play the ring tone for the
Incoming call when phone is on-hook.
Value Range: 5 to 120 seconds
Alert Tone
Timeout Default Value: 60 Seconds
Note: To work this feature, please ensure that this timeout
should be greater than the configured "Auto Answer After"
ring timeout
This is the maximum time for the remote party to answer
the call and ring back tone is played during this period.
No Answer Value Range: 5 to 120 seconds.
Timeout
Default Value: 60 seconds
GLV-540 User Manual
55