Konica Minolta bizhub C250 Service Manual page 1003

6. Board switch
[2] [1]
LED2 LED1
PSW2 PSW1
CN2
1 4 1
ON
1 2 3 4
ON
1 2 3 4
44
SW1
CN21
11
4583F3C516DA
5 6 7 8
5 6 7 8
4583F3C517DA
Field Service Ver. 1.0 Jul. 2005
6. After the initial operation of the Fin-
isher, press the PSW1 [1] on the Fin-
isher Control Board and make sure
that the alignment plate moves to the
selected paper size area.
7. Adjust the Alignment plate position
with PSW1 [1] or PSW2 [2].
When adjusting inward: Press
PSW1.
When adjusting outward: Press
PSW2.
The alignment plate will move
0.367mm every time the push switch
is pressed.
Alignment range is ± 2.936 mm.
8. When the adjustment is complete,
turn switch 8 of SW1 ON to set the
adjustment value.
9. Turn all adjustment switches OFF.
10. Turn main power switch OFF.
NOTE
• When not all SW1 are OFF in step 3,
return to the original condition
according to the written note.
11. Return the Finisher to the original
status.