Installing An Expansion Interface (Option); Using The Lan-Cable Hook - Roland M-5000 Reference Manual

Placement and Setup

Installing an Expansion Interface (Option)

You can expand the M-5000's input and output capabilities by
installing a separately available expansion interface into the unit's
expansion slot.
For information on the expansion interfaces that can be installed in
the M-5000, refer to the Roland website.
* When restarting the unit with the expansion interface installed,
wait for about one second before you turn on the power.
1.
Turn off the power to the M-5000 and unplug the power
cord from the power outlet.
2.
Loosen the mounting screws (2) for the expansion slot
specified in the figure, then detach the panel.
3.
Insert the expansion interface.
* To avoid the risk of damage to internal components that can
be caused by static electricity, please carefully observe the
following whenever you handle the expansion interface.
5 Before you touch the expansion interface, always first grasp
a metal object (such as a water pipe), so you are sure that
any static electricity you might have been carrying has been
discharged.
5 When handling the expansion interface, grasp it only by the
front panel or the expansion interface's edges. Avoid touching
any of the electronic components or connectors.
5 Save the bag in which the expansion interface was originally
shipped, and put the expansion interface back into it whenever
you need to store or transport it.
24
4.
Secure using the screws (2) for the expansion slot
specified in the figure.
* Install only the specified expansion interface. Remove only the
specified screws.
* Before installing the expansion interface, you must first always
turn off the unit and unplug its power cord.
* Do not touch any of the printed circuit pathways or connection
terminals.
* Never use excessive force when installing an expansion
interface. If it doesn't fit properly on the first attempt, remove
the expansion interface and try again.
* When expansion interface installation is complete, double-
check your work.
* Always turn the unit off and unplug the power cord before
attempting installation of the expansion interface.

Using the LAN-cable Hook

Engage the LAN cable connected to the LAN port on the LAN-cable
hook as shown in the figure to secure it in place. This can help
prevent inadvertent detachment of the LAN cable.
* Never apply strong force to the LAN cable.
* Never wind (bend) the LAN cable using a coil radius of 25
millimeters or less, or bend the cable sharply enough to kink it.