Installing An Interface Module (Option); Using The Lan-Cable Hook - Roland M-5000 Quick Start Manual

Placement and Setup

Installing an Interface Module (Option)

You can expand the M-5000's input and output capabilities by
installing a separately available interface module into the unit's
expansion slot.
For information on the interface modules that can be installed in
the M-5000, refer to the Roland website.
1.
Turn off the power to the M-5000 and unplug the power
cord from the power outlet.
2.
Loosen the mounting screws (2) for the expansion slot
specified in the figure, then detach the panel.
3.
Insert the interface module.
* To avoid the risk of damage to internal components that can
be caused by static electricity, please carefully observe the
following whenever you handle the interface module.
5 Before you touch the interface module, always first grasp
a metal object (such as a water pipe), so you are sure that
any static electricity you might have been carrying has been
discharged.
5 When handling the interface module, grasp it only by the panel
or the interface module's edges. Avoid touching any of the
electronic components or connectors.
5 Save the bag in which the interface module was originally
shipped, and put the interface module back into it whenever
you need to store or transport it.
4.
Secure using the screws (2) for the expansion slot
specified in the figure.
24
* Install only the specified interface module. Remove only the
specified screws.
* Before installing the interface module, you must first always turn
off the unit and unplug its power cord.
* Do not touch any of the printed circuit pathways or connection
terminals.
* Never use excessive force when installing an interface module. If
it doesn't fit properly on the first attempt, remove the interface
module and try again.
* When interface module installation is complete, double-check
your work.
* Always turn the unit off and unplug the power cord before
attempting installation of the interface module.

Using the LAN-cable Hook

Engage the LAN cable connected to the LAN port on the LAN-cable
hook as shown in the figure to secure it in place. This can help
prevent inadvertent detachment of the LAN cable.
* Never apply strong force to the LAN cable.
* Never wind (bend) the LAN cable using a coil radius of 25
millimeters or less, or bend the cable sharply enough to kink it.