R
LCR
C
INS A/B SEND
Inserting External Effects Devices
L
LR
R
C
C
IN SEL
INS A/B SEND
MAIN OUT
L
About Inserting External Effects Devices
LR
MIX-MINUS OUT
R
SUBGROUP OUT
AUX OUT
MATRIX OUT
IN SEL
INS A/B SEND
You can connect external effects devices to input and output
connectors on the M-5000 and on input and output units
connected to the M-5000, and insert the devices into input
channels, output buses, and monitors.
You make the settings for inserting external effects devices in the
INSERT SETTINGS window.
INSERT SETTINGS Window
To display the INSERT SETTINGS window, go to the SETUP window
and tap <INSERT SETTINGS>.
NAME
SEND
RETURN
48V
PAD
PREAMP (RETURN)
INSERT
CLEAR
GEQ 1 / PEQ 1
GEQ 32 / PEQ 32
FX 1–8
OUT SEL
2
2
FX 1
2
2
FX 8
INSERT 1–64
OUT SEL
FROM PATCHBAY
SEND
RETURN
INSERT 1
LEVEL
LEVEL
TO PATCHBAY
FROM PATCHBAY
SEND
RETURN
INSERT 64
LEVEL
LEVEL
TO PATCHBAY
Here you enter the name of the external effects
device.
Specifies output to the external effects device.
At the left, you set the output connector.
At the right, you adjust the output level.
Specifies the input from the external effects
device.
At the left, you set the input connector.
At the right, you adjust the input level.
Input-connector phantom power
Input-connector pad
Preamp setting for the input-connector
Input channel/output bus where inserted
Clears all insert settings for all external effects
devices.
INS A/B RETURN
Inserting an External Effects Device
INS A/B RETURN
PATCHBAY
1.
Display the INSERT SETTINGS window.
2.
Use <SEND> to specify the output connector where the
external effects device is connected.
INS A/B RETURN
3.
Use <RETURN> to specify the input connector where the
external effects device is connected.
AUX OUT
MATRIX OUT
SOLO 1
2
TRIM
MONITOR 1 (5.1, LCR or STEREO)
MONITOR 2 (STEREO or NONE)
HEADPHONES (MONITOR 1 or MONITOR 2)
SOLO 2
2
TRIM
LEVEL
LEVEL
TB RTN
195