Communication - METREL MI 3122 Instruction Manual

MI 3122 Smartec Z Line-Loop / RCD
6.6

Communication

Stored results can be transferred to a PC. A special communication program on the PC
automatically identifies the instrument and enables data transfer between the instrument
and the PC.
There are two communication interfaces available on the instrument: USB or RS 232.
The instrument automatically selects the communication mode according to detected
interface. USB interface has priority.
Figure 6.12: Interface connection for data transfer over PC COM port
How to transfer stored data:
RS 232 communication: connect a PC COM port to the instrument PS/2 connector

using the PS/2 - RS232 serial communication cable;
USB communication selected: connect a PC USB port to the instrument USB

connector using the USB interface cable.
Switch on the PC and the instrument.

Run the EurolinkPRO program.

The PC and the instrument will automatically recognize each other.

The instrument is prepared to download data to the PC.

The program EurolinkPRO is a PC software running on Windows XP, Windows Vista,
Windows 7, and Windows 8. Read the file README_EuroLink.txt on CD for instructions
about installing and running the program.
Note:
USB drivers should be installed on PC before using the USB interface. Refer to

USB installation instructions available on installation CD.
44
Communication