Applied Operation With Input And Output Signals (Operation By Terminal Board; Functions Of Input Terminals (In Case Of Sink Logic - Toshiba VF-PS1 Instruction Manual

7.2

Applied operation with input and output signals (operation by terminal board)

7.2.1 Functions of input terminals (in case of sink logic)

Use the above parameters to send signals from an external programmable controller to various control input terminals
to operate and/or set the inverter.
The desired contact input terminal functions can be selected from about 80 types. This gives system design flexibility.
[Control terminal board]
Setting of contact input terminal function
Terminal
symbol
-

-
, 
F 
R

RES 
S1
7 
S2

S3

RR/S4 
LI1~LI8
~
Note: When ,  and  (Always ON function selection 1~3) are selected, selected function is
generally activated regardless of positive or negative logic.
Note: ~ is for use of expansion terminal board option unit.
Connection method
1) In case of positive logic (a-contact) input
Inverter
Input terminal
2) In case of negative logic (b-contact) input
Inverter
Input terminal
Title
Always ON function selection 1
Always ON function selection 2, 3
Input terminal function selection 1 (F)
Input terminal function selection 2 (R)
Input terminal function selection 4 (RES)
Input terminal function selection 5 (S1)
Input terminal function selection 6 (S2)
Input terminal function selection 7 (S3)
Input terminal function selection 8 (RR/S4)
Input terminal function selection 9~16
A-contact switch
CC
B-contact switch
CC
Adjustmen
Function
to Section
This function is activated when the input
terminal and CC (common) are short-circuited.
Use this function to specify forward/reverse
run or a preset speed operation.
This function is activated when the input
terminal and CC (common) are open-circuit.
Use this function to specify operation standby
signal or reset signal.
G-2
E6581386
Default setting
t range
(Standby)
(No function is
assigned)
~
(Forward run)
(Reverse run)
⇒ Refer
 (Reset)
 (Preset speed 1)
7.2.1.
(Preset speed 2)
(Preset speed 3)
(Preset speed 4)
