An example of setting: When is , and is
Panel indication
Panel indication
6.31.3 Changing the steps in which the value displayed changes
: Changing step selection 1 (pressing a panel key once)
: Change step selection 2 (panel display)
• Function
6
These parameters are used to specify steps in which the command value or standard monitor output
frequency displayed on the panel changes each time you press the up or down key to set a frequency on
the operation panel.
Note: The settings of these parameters have no effect when the free unit selection ( ) is enabled.
When is not , and is (disabled).
Under normal conditions, the panel frequency command value increases in steps of 0.1Hz each time you press the
key. If is not 0.00, the frequency command value will increase by the value with each time you
press the
In this case, the output frequency displayed in standard monitor mode changes in steps of 0.1Hz, as usual.
When is not , and is not .
The value displayed on the panel also can be changed in steps.
Output frequency displayed in standard monitor = Internally output frequency ×
Title
Example of setting 1
Set =[Hz]:
Each time you press the
20.0 → ... → 60.0 [Hz]. This function comes in very handy when operating the load at limited frequencies that
change in steps of 1 Hz, 5Hz, 10Hz, and so on.
Example of setting 2
Set =[Hz], =:
Each time you press the
and also the value displayed on the operation panel changes in steps of 1. Use these settings to hide decimal
fractions. And also the value displayed on the operation panel changes in steps of 1. Use these settings to hide
decimal fractions.
=, =
800
0
0
Output frequency
=, =
800
0
0
Output frequency 80 (Hz)
key. Similarly, it will decrease by the value set with each time you press the
Function
Changing step selection 1
(pressing a panel key once)
Changing step selection 2
(panel display)
key, Each time the frequency setting changes in steps of 10.0Hz: 0.0 → 10.0 →
key, the frequency setting changes in steps of 1 Hz: 0 → 1 → 2 → ... → 60 [Hz]
=, =
Panel indication
1000
200
0
80(Hz)
0
Adjustment range
.:Disabled
.~ Hz
:Disabled
~
F-66
E6581386
80(Hz)
Output frequency
key.
Default setting
.