Toshiba VF-PS1 Instruction Manual page 194

Table of setting of contact input terminal function
Parameter setting
Positive Negative
logic logic
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
7
 
*1: Valid when  (Frequency setting mode selection 1) is set at  (Up/down frequency).
The frequency setting range is between =  ~  (Upper limit frequency). The acceleration/deceleration time
with respect to the frequency setting remains  /  , unless switching between acceleration and
deceleration is performed.
*2: If  ,  (F: Forward run command) or  ,  (R: Reverse run command) is assigned at the same time, this
function has a priority.
*3: After the motor slows down and comes to a full stop at a pre-excitation command, the motor is set free
momentarily to bring it into a pre-excitation state.
This function should not be used when  is set to  or  . Or the inverter might malfunction.
*4: Do not specify any number other than those listed in this table.
Sink logic/source logic
Switching between sink logic and source logic (input/output terminal logic) is possible.
⇒ For details, refer to the Section 2.3.2.
Function
No function is assigned
F: Forward run command
R: Reverse run command
ST: Standby
RES: Reset
S1: Preset speed 1
S2: Preset speed 2
S3: Preset speed 3
S4: Preset speed 4
Jog run
Emergency stop
DC braking
Acceleration/deceleration switching 1
V/f switching signal 1
PID control OFF selection
External thermal error
Communication priority cancel
HD operation retention
PID differentiation/integration clear
PID forward/reverse switching
Forced continuous operation
Specified speed operation
My function RUN signal
Auto-tuning signal
Integrating wattmeter display clear
Parameter setting
Positive Negative
logic logic
  Trace back trigger signal
No function assigned
 
No function assigned
 
No function assigned
 
Binary data write
 
Up/down frequency (up)
 
Up/down frequency (down)
 
Up/down frequency (clear)
 
No function assigned
 
No function assigned
 
Forward/reverse selection
 
Run/stop command
 
Commercial power/INV switching
 
Frequency reference priority switching
 
  VI/II terminal priority
  Command terminal board priority
  Permission of parameter editing
  No function assigned
No function assigned
 
  No function assigned
  No function assigned
Rapidest deceleration command
 
Preliminary excitation
 
No function assigned
 
No function assigned
 
G-4
E6581386
Function
*1
*1
*3
*4