Multi-Cell System Setup; Primary Base Station Configuration; Sample Multi-Cell System Information; Summary: Multi-Cell System Configuration - Toshiba IP4100 Installation Manual

MULTI-CELL SYSTEM SETUP

MULTI-CELL SYSTEM
SETUP
Table 1-8

Summary: Multi-cell System Configuration

1 Place the primary base station at its final location.
2 Configure the primary base station.
3 Reboot the primary base station and verify the settings.
4 Place each Level 1 base station at its final location.
5 Configure each Level 1 base station and reboot.
6 Synchronize each Level 1 base station.
7 Repeat the process with each Level 2 base station.
8 Repeat the process with any base stations at Level 3 through Level 6.
Primary Base Station
Configuration
IP4100 Install Sept., 2013
Table 1-7

Sample Multi-cell System Information

Base Station
(assigned by system)
Base #0
Base #1
Base #2
Base #3
Base #4
Base #5
Base #6
Base #7
The table below shows a top-level summary of the steps needed to set up
a multi-cell system.
Step
Perform the following steps on the primary base station only. For all other
base stations refer to "Configure Level 1 Base Stations"
1. Place the primary base station at its final location. (See the Network
Planning Guide for information on the proper placement of base
stations.)
2. Login to the base station.

Primary Base Station Configuration

RPN
Synchronization Source
00 RPN 00 (self)
04 RPN 00 (Base #0)
08 RPN 00 (Base #0)
0C RPN 04 (Base #1)
10 RPN 08 (Base #2)
14 RPN 0C (Base #3)
18 RPN 10 (Base #4)
1C RPN 10 (Base #4)
Screens Used
NA
Multi-cell
Home/Status
NA
Multi-cell
Home/Status
Multi-cell
Multi-cell
Home/Status
Multi-cell
Home/Status
on page 1-25.
1-23