Dect System Settings Parameters - Toshiba IP4100 Installation Manual

BASE STATION CONFIGURATION
Table 3-19 Settings for This Unit Parameters
Parameter
Multi cell debug
Table 3-20 DECT System Settings Parameters
Parameter
DECT system RFPI
Auto configure DECT
sync source tree
Table 3-21 Base Station Settings Parameters
Parameter
Number of SIP accounts
before distributed load
SIP support for multiple
registrations per account
IP4100 Install Sept., 2013
Select:
– Off – To not include any multi cell logs in the
syslogs. This is the recommended setting
unless requested otherwise by a technician.
A lot of logs are generated when the other
selections are chosen.
– Data Sync – To include in the syslogs logs
regarding which signals are received from
which IP addresses. Timeout handling and
state changes are logged.
– Auto tree – To include in the syslogs logs
regarding events triggering the
reconfiguration of the DECT chain, and
timeouts within Auto tree are logged.
– Both – To include both Data sync and Auto
tree logs in the syslogs.
The radio network identity used by all base stations in a specific chain to
communicate with each other. (See
details.)
This setting should remain disabled.
Enter the maximum number of handset registrations (up to 30) you
want each base station in the chain to be able to handle. If the
number of registered handsets at a particular base station goes
beyond the number entered here, extra handsets will be distributed
to other base stations in this chain.
Select Enabled to allow more than one handset to use the same
extension or SIP account; if this feature is not supported by the IP
telephone system, this field is disabled.
(continued)
Description
Description
"RFPI Numbers" on
Description
Multi Cell Screen
page 4-1 for
3-17