System Maintenance; Configuration Settings; Backup Configuration Settings; Restore A Configuration - Toshiba IP4100 Installation Manual

SYSTEM MAINTENANCE

SYSTEM MAINTENANCE
CONFIGURATION
SETTINGS
Backup Configuration
Settings

Restore A Configuration

UPDATING THE
FIRMWARE
1-30
5. For the original Primary base station, select the new Primary or
another base station within its range as its DECT Sync Source.
6. Click Save.
7. Login to the original primary base station, and go to the Multi Cell
screen.
8. Click Reboot.
9. After reboot, on the Home/Status screen, verify that it reads Multi cell
Ready (Keep-alive) Secondary.
10. Login to the new primary base station. On the Home/Status screen,
verify that it reads Multi cell Ready (Keep-alive) Primary.
11. Go to the Multi Cell screen. Check the Base Station Group table and
verify that all base stations have properly resynchronized.
This section covers IP4100 system maintenance functions including base
station system configuration backup and restore, firmware update, and
handset maintenance.
This procedure saves the Base Station configuration on a network
storage device.
1. Configure the first base station completely and save the
configuration.
2. In the left hand panel, click on Configuration. This opens the
Configuration screen.
3. At the top of the screen, click Save.
4. Save the file with a .cfg extension to a designated location for
managing base station configuration settings.
1. Login to the base station interface (refer to
INTERFACE" on page
2. Click Browse and select the configuration file for this base station.
3. 3) Click Load, then reboot the base station.
4. 4) When the base station finishes rebooting, check the configuration
settings to be sure they loaded correctly.
You can update the firmware on base stations and handsets remotely via
a TFTP server. Update software files are available from Toshiba's FYI
website.
Note: The Base Stations and the Handsets must have the same version
firmware (i.e.: v0306). Do not downgrade handsets from V306 to
an older version or the handset will become inoperable.

Backup Configuration Settings

"BASE STATION
1-10), and go to the Configuration screen.
IP4100 Install Sept., 2013