Firmware Update Screen - Toshiba IP4100 Installation Manual

UPDATING THE FIRMWARE
Figure 1-26 Firmware Update screen
1-34
2. Login to the base station configuration interface (refer to
STATION INTERFACE"
Update screen.
3. Under the Update Base Stations section, select Update this Base
Station only to update only the base station you are currently
connected to. To update all base stations at the same time, select
Update all Base Stations.
4. Enter the last three digits of the firmware filename in the Required
version field. The required version identifies the firmware file
containing the update; for example, if you want to update the base
station to the firmware file BeatusSW_4181_v0306.fwu, enter 306 in
the Required version field.
5. Click Start update. When the base station asks you to confirm, click
OK.
• The base station firmware download will start. (You can check the
download progress in the relevant log of your TFTP Server
application.) The base station configuration interface will be
temporarily unavailable when the base station(s) reboot at the
end of the download. The overall update for a base station takes
several minutes.
• To verify the firmware update, go to the Home/Status screen and
check the Firmware-Version field. The field shows the current
firmware version in the format IPDECT/{Required FW version}/
{date of FW file}, so in this example, the field should read
Update Base Station Firmware
on page 1-10), and go to the Firmware
IP4100 Install Sept., 2013
"BASE