Base Station Group Parameters - Toshiba IP4100 Installation Manual

BASE STATION CONFIGURATION
Table 3-22 Base Station Group Parameters
Parameters
ID (chain)
RPN
(DECT network)
MAC Address
Version
Status
DECT Sync
source
DECT Property
Base station
name
3-18
Displays the ID number of the base stations in this chain, usually
corresponding to the order the base stations were added to the chain. (The
same ID number might be used in other chains.)
Displays the Radio Part Number (DECT network ID) of the base stations on
this chain. The RPN is automatically assigned by the system, and it must be
unique on the local DECT network. (The same RPN might be used at remote
locations.)
Displays the MAC address of each base station.
Displays the current firmware version on each base station.
– Connected: The base station is connected and functioning properly.
– Connection Loss: The base station is not connected to the network.
– This Unit: The base station is the one you are currently logged into.
– Select the synchronization source for each base station on this
chain. The primary base station has its own RPN as the sync source.
– The value in parentheses after the RPN shows the relative signal
strength of the other base stations in this chain.
Primary: The designated base station serves as the primary synchronization
source for this chain.
Locked: The base station is synchronized to its sync source.
Searching: The base station is locating its sync source.
Free Running: The base station was locked, but it has since lost its
synchronization source.
Unknown: There is no current connection to the base station.
Displays the name of each base station (as configured on the Management
screen)
Description
IP4100 Install Sept., 2013
Multi Cell Screen