Sample Multi-Cell System - Toshiba IP4100 Installation Manual

MULTIPLE BASE (MULTI-CELL) SYSTEMS
1-22
Within the system chain, each base station is automatically assigned an
RPN identification number. When you select a synchronization source for
each base station, you will use the source's RPN to identify it.
• The system assigns the RPN based on the order in which the base
stations are added to the chain. For example, the first base station
added to the chain (usually the primary) is assigned an RPN of 00,
the second base is assigned an RPN of 04.
• If you want the base stations to appear in a particular sequence, add
the stations to the chain in that order.
Figure 1-17 shows an example of a multi-cell system, and Table 5
summarizes the parameters for this example. This information is used
throughout the instructions.
Figure 1-17 Sample Multi-cell System
System Chain ID and RPN
IP4100 Install Sept., 2013