Configuring Sip Server Settings; Servers Screen; Sip Server Setting Parameters - Toshiba IP4100 Installation Manual

GENERAL SYSTEM CONFIGURATION
Configuring SIP Server
Settings
Table 1-5

SIP Server Setting Parameters

Parameter
NAT Adaptation
SIP Server
Outbound Proxy
1-16
The SIP server is the IPedge or Strata CIX system.
1. In the Network screen (refer to
parameters under the SIP/RTP Settings are correct.
2. In the left panel of the screen, select Servers. This opens the Servers
screen.
Figure 1-12 Servers screen
3. Click on Add Server, then enter the necessary information for the first
IPedge or Strata CIX system. Refer to
NO: The Base Station disregards information from the report and
Received parameters. This is the typical configuration.
YES: If information in the report and received parameters is different
from local information, the Base will perform new SIP registration with
the new information in the Contact header. If information in report and
Received parameters is not different from local information then no
action is performed.
Enter the IP address of the IPedge server or the MIPU card of the
Strata CIX system. If desired, you can add the port number after the IP
address using the format {IPadddress}:{port}"
If there is a SIP Proxy, between the base station and the IPedge or
Strata CIX system, enter the IP address of the SIP Proxy. If desired,
you can add the port number after the IP address using the format
{IPaddress}:{port} (e.g., 192.168.250.111:5060).
(Sheet 1 of 2)

Configuring SIP Server Settings

Figure 1-10) ensure that the
NO
Table 1-5.
Meaning
IP4100 Install Sept., 2013