Setting Up The Gs50 / Gs50+ For Field Data Collection - Leica GS50 User Manual

3.2.2 Setting up the GS50 / GS50+ for field data collection

The following will outline the steps
necessary to set up the GS50 /
GS50+ sensor for field data collec-
tion.
1. Connect the antenna to the sensor
using the antenna cable.
2. Plug two GEB121 batteries into
the backside of the sensor.
Alternatively, you may want to
power the sensor externally. In this
case, connect the external power
source to the Power port on the
front of the sensor.
For an external power
source, use only the Leica
Geosystems battery pack, or a
stable 12V source.
GS50 / GS50+-4.0.0en
3. Attach the TR500 terminal to the
sensor, either directly or via a
connection cable by plugging it
into the TERMINAL port on the
sensor.
13
4. Insert a PC-Card into the
sensor.
Lock the lid carefully after insertion
of the card in order to prevent water
and dust from getting inside the
sensor.
Never insert or remove PC
cards with the system
powered on!
Your GS50 / GS50+ sensor is now
fully ready for operation.
Getting Started With New Equipment