Leica GS50 User Manual page 40

3.3.3 QuickStart Tutorial- GIS Navigation/Update, contd.
Navigate by Line or Area
Navigation by Line or Area allows
the user to navigate along a complex
object, observing their location (plus)
in relation to the object and the
vertex (x) of interest. In addition to
the ability to view and delete points
along an object, the new navigation
function allows the user to add or
edit new points along the complex
object.
While you are in the Graphic screen
SHIFT F2 REDO allows you to add
an additional new data stream. Both
the existing feature and the newly
measured feature are displayed
simultaneously.
Getting Started With New Equipment
Step 5: Verifying or updating
waypoint information (MANAGE\
Edit Point)
After navigating to the waypoint and
collecting position information, you
can check the feature's non-spatial
attribute information.
1. Highlight the waypoint field and
press ENTER.
2. To edit the waypoint's attributes,
press F3 ATTRIB.
The following panel should appear:
40
The ATTRIBUTION\ Edit Point panel
allows you to change a waypoints
attached code as well as its at-
tributes. Generally, waypoints will
have been created by converting an
existing code into a waypoint in the
office software (Please refer to the
Getting started with GIS DataPRO
Office Manual). The attributes from
the initial data collection will remain
with the waypoint since the code is
attached. These attributes can be
checked and updated in the field
from the ATTRIBUTION\ Edit panel.
3. Press F1 CONT to update the
waypoint.
4. This will bring you back to the
waypoint list. Select the next
waypoint you wish to navigate to,
and press ENTER.
5. Repeat steps 3 and 4 until all
waypoints have been updated.
GS50 / GS50+-4.0.0en