Leica GS50 User Manual page 22

3.3.2 QuickStart Tutorial - GIS Data Collection, contd.
If no real time differential corrections
are used (i.e. you do not have the
RTCM differential beacon module
attached to the sensor), you should
select the GIS_PP (PP = Post
Processing) configuration set. You
can make this selection either by
using the "cursor left" key to toggle
between all available configuration
sets until GIS_PP appears or you
can highlight the input field and
press ENTER. Then a listbox comes
up showing all available sets:
Now use the cursor up or cursor
down key on the terminal to highlight
the GIS_PP line. Then press ENTER
or F1 CONT.
Getting Started With New Equipment
Step 3: Choosing your Job name
(DATA COLL \ Begin)
Jobs are used to organize and
structure the data you collect in the
field. Jobs can comprise an unlimited
number of points together with all
related information (raw measure-
ments, codes, etc.).
It is suggested to create a new job
whenever you start a new project.
Upon formatting the memory device
(i.e. PC-Card or internal memory
(optional) ) a default job is automati-
cally created.
You can decide whether you like to
create manually jobs or a automati-
cally generated job everyday you are
using the GIS Data Collection. To
activate the automatically creation
press the CONFIG key change to 3
'General' and select 5 'Start - Up'.
Highlight the 'new Job' field and
select 'New Job per day'.
22
You can either use this Job straight
away or you can create Your own job
by doing the following:
Move the cursor up or cursor down
key of the terminal into the input field
for jobs. Then press ENTER. The
following listbox will appear:
Now press F2 NEW. The following
panel appears:
GS50 / GS50+-4.0.0en