Leica GS50 User Manual page 32

3.3.2 QuickStart Tutorial - GIS Data Collection, contd.
To avoid such scenarios the system
gives a suggestion for the minimum
node distance of lines / areas when
offset left or right is used. The value
is calculated by half of the line / area
offset.
In the ATTRIBUTION \ Distance
panel press F1 CONT to accept the
suggested value for the minimal
Node distances.
The minimal distance value can be
changed within the ATTRIBUTION
panel by pressing SHIFT F3 DIST.
Line and area offsets will
only work for real time data
collection.
There are three ways to collect line
or area data: streaming by time,
streaming by distance, or noded.
Getting Started With New Equipment
Streaming Line Data by Time
Begin logging line data by pressing
F1 START. Notice that the GS50 /
GS50+ begins making measure-
ments at a constant rate (default is 1
Hz) and informs you of how many
nodes have been measured.
The line/area data log rate
can be changed from the
CONFIGURE\Position
panel.
32
Streaming Line Data by Distance
You can also measure lines and
areas by distance.From the line
attribution panel, press Shift F3
DIST.
Enter the desired distance between
nodes and press F1 CONT. You will
be taken back to the line attribution
panel. Press F1 Start to begin
collecting the line or area feature by
distance. This configuration will
remain in memory until the receiver
is powered down.
GS50 / GS50+-4.0.0en