Table of Contents
Advertisement
2.1 GS50 / GS50+ Sensor, contd.
GPS Receiver
The TR500 terminal fits either directly on the receiver or can be connected to the terminal port using a cable.
A radio modem or an RTB module can also be fitted directly to the receiver. Alternatively, if the housing is not being
used, the radio modem can be connected to Port 1 or Port 2 using a cable. The GS50+ has an additional Port (Port 3
at the upper left side of the front plate ) that can be used also for Power/data in/out put.
The antenna is connected to the receiver via the ANT Port.
External power can be connected via a cable through the power port (PWR) or Port 2.
1.
5 pin Lemo. Power
2.
Power ON/OFF
3.
GPS Antenna in.
4.
Port 2. 5 pin Lemo. Power/data in/out.
5.
Pressure equalization vent.
6.
Port 1. 8 pin Lemo. Power/data in/out.
7.
PC Card door.
8.
Terminal in/out or Remote Interface in/out.
9.
Port 3. 8 pin Lemo Power/data in/out
(GS50+ only)
GS50 / GS50+-4.0.0en
9
8
1
2
3
9
7
4
5
6
System Description
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
