Leica GS50 User Manual page 37

3.3.3 QuickStart Tutorial- GIS Navigation/Update, contd.
The NAVIGATION\ Begin panel
allows you to set your configuration
set, the source job for your
waypoints, the codelist, and the
antenna type.
2. Highlight and press ENTER on the
Config Set field. Choose a
predefined configuration set, or
create your own.
In order to navigate to
waypoints, you must choose
a configuration set that supports real
time data collection. Also make sure
you are referencing the correct
coordinate systems. (F6 "CSYS")
3. Highlight and press ENTER on the
Waypoints field. The waypoint
project that you transferred onto
the PCMCIA card should appear
in the Waypoints listbox.
GS50 / GS50+-4.0.0en
4. Highlight and press ENTER on the
Collect to field. (Only applicable
for ASCII waypoint files)
5. Highlight and press ENTER on the
Codelist field to select a codelist to
use for the navigation (field up-
date) project.
6. Press F1 CONT to continue with
waypoint navigation.
You can also read waypoints from an
ASCII file. Press the F4 ASCII key to
change the source of the waypoints
from a Job to an ASCII file. You can
also configure the ASCII file pressing
F4 ASCII again. This will take you to
the CONFIGURE\Pt ASCII File
Format panel.
37
The ASCII file should be placed in
the /Data/ directory on the PCMCIA
card. When navigating from an
ASCII file, you will need to write the
data (collect to) to a Job.
Getting Started With New Equipment