Leica GS50 User Manual page 33

3.3.2 QuickStart Tutorial - GIS Data Collection, contd.
Noded Line Data
You can also collect data at the
nodes of the line (i.e. where the line
changes direction). Move to the first
node in the line and press F3 Node.
A counter will appear on the panel
and will count up to 5. Five observa-
tions are recorded at each node.
Repeat this for as many nodes as
are needed. Once a minimum of two
nodes are collected, the F1 DONE
key will appear. Press F1 DONE to
end the line data collection.
GS50 / GS50+-4.0.0en
The antenna must not be
moved while noded data is
logged, otherwise the quality of the
collected data will be degraded!
You can change the number
of positions which are
collected for a static node in the
Configuration setting from the
CONFIGURE \Occupation panel with
F4 NODES or via the CONFIG key
followed by '2 Operation' and '2
Occupation Settings'.
While you are in the Attribu-
tion panel Shift F2 PtLst
allows you to add any, already
measured point, out of the point list
as a new node.
33
Nested data collection
While collecting line or area data, it
is possible to interrupt the current
data collection, and collect data for
any other code in your codelist. The
following outlines the steps neces-
sary to collect a nested point:
• Press F2 NESTD.
• Select any code from the
codelist.
• Press F1 OCUPY/START to
begin the nested data collec-
tion.
• Press F1 STOP to stop the
nested data collection.
The panel should return to the code
for which data collection has been
paused.
• Press F4 RESUM to finish the
line or area or
• Press F2 NESTD to collect
another nested feature.
Getting Started With New Equipment