Table of Contents
Advertisement
13
Adjusting the height and feed roller clearance of the hot air nozzle
.07 .02
Requirement
1. The height adjustment of not air nozzle 5 depends on the material, and the standard
setting is centred to the feed rollers.
2. There should be clearance of ca. 1 -2 mm between hot air nozzle 5 and the workpiece.
Fig. 13 - 08
● Switch on the machine and set the sealing temperature to its minimum value.
● Call up the input menu.
● Position the heating element.
● Adjust screw 1 (clamp screw 2) in accordance with requirement 1.
● Adjust screw 3 (clamp screw 4) in accordance with requirement 2.
● Switch off the machine.
4
3
1
2
Adjustment
5
93
Advertisement
Table of Contents
