Double Foot Switch (Optional) - Pfaff 8390 Instruction Manual

Controls
7 Double foot switch
.05
During the sealing process
● By pressing the foot switch 1 or 2 , the adjustable speed difference from carriage speed
1 = Decrease carriage speed over the roller speed (reduction of material build-up)
2 = Increase carriage speed over the roller speed
After a sealing stop (switch / correct the carriage position to the sealing material)
● By pressing the foot switch 1 or 2 the carriage is moved.
1 = move the carriage slowly against the sealing direction
2 = move the carriage slowly in the sealing direction
In the carriage menu
● By pressing the foot switch 1 or 2 the carriage is moved.
1 = Move the carriage slowly against the sealing direction (after 3 seconds with the foot
2 = Move the carriage slowly in the sealing direction (after 3 seconds with the foot switch
During the sealing process with parameter "Diffmode = 1"
● By pressing the foot switch 1 or 2 , the value for the differential correction (speed differ-
1 = Gradually decrease speed of the top feed roller
2 = Gradually increase speed of the top feed roller
18
Fig. 7 - 05
to roller speed is switched. The value of the speed difference can be set under parameter
Gswred (see Chapter 13.14.02).
switch pressed, change-over to high speed)
pressed, change-over to high speed)
ence from top to bottom feed roller) is gradually altered.
The differential correction is displayed in % on the control panel.
(optional)
2
1