Related Manuals for Pfaff 80
Summary of Contents for Pfaff 80
- Page 6 DR 510...
- Page 7 Removing the Bobbin Case Raise needle to its highest point. Lift front end of bed slide and pull. Lift latch Ic with the thumb of your left hand and pull out bobbin case with bobbin. When you release the latch, the empty bobbin drops out.
- Page 17 DR 079 R 8029...
- Page 18 ‘...
- Page 20 —...
- Page 23 Quilting Edge stitcher No. 93-847600-00 used with the quilting gauge sews parallel rows of stitching over the entire surface of the fabric. Alwoys guide the gouge finger along the preceding seam. Attractive tea cosies, slippers, seat pads and covers can be quilted.
- Page 27 Darning with Sewing Foot No. 93439 950-00 Triangular tears, small rips or thin spots are best darned by making close stitches back and forth over the area to be darned. To do this, attach the sew ing foot and set the needle plate in the normal position.
- Page 30 in filmy ill, 26). Lay Pull Tucks tucks, tucks, ill. DR 521...
- Page 31 Various Cording Effects Attractive cording effects may be ob tained by combining horizontal, verti cal and diagonal tucks or stitching curved tucks (see adjoining ill.). If you want to turn a corner, leave needle in fabric (up to needle eye only), lift foot, turn fabric, lower foot, and continue sewing.
- Page 37 Removing the Face Cover To change the light bulb or oil the parts at the needle bar end, remove the face cover by pulling it upwards. Replacing the Face Cover Slip tip d into slot e and push face cover up until it snaps into place. DR 024 DR 512...
- Page 38 Changing the Light Bulb The built-in 15-watt sewing light illumi nates the area of stitching perfectly. To change the light bulb, remove the face cover, push the bulb into its socket, turn left, and pull out, When inserting a new light bulb, make sure its voltage agrees with the line voltage.
- Page 40 2. Needle Thread Breaks Cause: Remedy: The above-mentioned may cause See remedies listed under 1. above. thread breakage. Thread tension too tight. Adjust tensions as instructed. Poor, knotty or rotten thread used. Use good-quality threods only. Hook raceway is jammed with thread Clean and oil hook raceway.