Adjustment; Notes On Adjustment; Tools, Gauges And Other Accessories - Pfaff 8390 Instruction Manual

13

Adjustment

13

Notes on adjustment

.01
All following adjustments are based on a fully assembled machine and may only be carried
out by expert staff trained for this purpose.
Machine covers, which have to be removed and replaced to carry out checks and adjust-
ments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence for ma-
chines which have to be completely adjusted. If only specifi c individual work steps are
carried out, both the preceding and following chapters must be observed.
Screws, nuts indicated in brackets ( ) are fastenings for machine parts, which must be loo-
sened before adjustment and tightened again afterwards.
13

Tools, gauges and other accessories

.02
● 1 set of screwdrivers with blade widths from 2 to 10 mm
● 1 set of open-ended wrenches with opening sizes from 7 to 17 mm
● 1 set of allen keys from 1.5 to 6 mm
● 1 wire brush
Unless stated otherwise, during all adjustment work the machine
must be disconnected from the electric and pneumatic power supply!
Danger of injury if the machine is started accidentally!
Before all adjustment work switch the machine off and let it cool down!
Danger of burns if the hot-air nozzle is touched!
Adjustment
85