Safety; Directives; General Notes On Safety - Pfaff 8390 Instruction Manual

Safety

1 Safety
1

Directives

.01
This machine is constructed in accordance with the European regulations indicated in the
conformity and manufacturer's declarations.
In addition to this instruction manual, please also observe all generally accepted, statutory
and other legal requirements, including those of the user's country, and the applicable pollu-
tion control regulations! The valid regulations of the regional social insurance society for oc-
cupational accidents or other supervisory authorities are to be strictly adhered to!
1

General notes on safety

.02
● The machine may only be operated by adequately trained operators and only after these
● The danger and safety instructions attached to the machine must be followed!
● The machine may only be used for the purpose intended and may not be operated wi-
● When changing the feed rollers or the hot air nozzle, when leaving the machine unatten-
● The daily maintenance work may only be carried out by appropriately trained personnel!
● During repair and maintenance work on pneumatic devices the machine must be discon-
● Repairs and special maintenance work may only be carried out by qualifi ed service staff
● Work on electrical equipment may only be carried out by appropriately trained personnel!
● Work is not permitted on parts and equipment which are connected to the power supply!
● Modifi cations and alterations to the machine may only be carried out under observance
● Only spare parts which have been approved by us are to be used for repairs! We draw
6
have read the appropriate Instruction Manual!
thout its safety devices. All relevant safety regulations must be adhered to.
ded or during maintenance work, the machine must be disconnected from the power
supply by operating the main switch or by pulling out the plug!
nected from the pneumatic supply system! The only exceptions permitted are during ad-
justment work and function tests carried out by appropriately trained personnel!
or appropriately trained personnel!
Exceptions to this rule are found in the regulations EN 50110.
of all the relevant safety operations!
special attention to the fact that spare parts and accessories not supplied by us have not
been subjected to testing nor approval by us. Fitting and/or use of any such parts may
cause negative changes to the design characteristics of the machine. We shall not accept
any liability for damage caused by the use of non-original parts.