Table of Contents
Advertisement
Preparation
After selecting "Manual Heat Sealing", also see Chapter 9.02 Selecting the production
type:, following values can be entered depending on the sealing method:
-
-
- Type of heating wedge or heating nozzle with hot air volume
-
The values can be entered directly by pressing the appropriate key symbol.
32
Sealing temperature
In addition to the set sealing temperature, the value for the parameter (off = heating off)
appears in the appropriate symbol as well as the actual sealing temperature.
Sealing speed
In addition to the sealing speed, the value for the difference in speed in % between the
top and bottom feed rollers appears in the appropriate symbol.
Roller pressure
In Programmed Heat Sealing the direct input of sealing parameters is not
possible. The alteration must be made in the appropriate sealing program,
see Chapter 10.03 Creating/altering a heat sealing program.
After switching the machine on, after the "pause" function or after detection of
an error, the heating element is switched off (parameter "OFF"). After changing
the sealing temperature, pressing the "start" function or after operating the
pedal, the heating element is switched on again.
Advertisement
Table of Contents
