IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this household accessory. When using an electrical appliance and it’s accessories, basic safety precautions should always be followed, including the following: Keep the instructions at a suitable place close to the machine. Make sure to hand them over if the machine is given to a third party.
Page 3
N. Threading Wire Introduction With the Creative Embellishment Attachment you can create embroideries with a texture that literally stands out! Rather than simple stitches on the surface of the fabric, the texture of the ribbon, yarn or bead results in embroideries that seem to jump off of the material.
Find the Ribbon, Yarn and String of Beads embroidery tutorials in the “Embellishment Attachment” or “Embroidery Accessories” sections. To see which designs you can make using the Creative Embellishment Attachment, please see your Sampler Booklet mySewnet Library.
Page 5
Wind the Embellishments on to the Spool The length of the embellishment needed for a design is listed in the Sampler Booklet and in the Quick Help available for each embellishment color block. 1. Place the spool in the spool storage unit, with the rectangular slot to the right if you are winding rib- bons.
Page 6
Thread Ribbon into the Base This section describes how to thread the ribbon to the base. For instructions about how to thread yarn or beads into the base, see next section. Turn the Embellishment Attachment over for easier threading. Once the ribbon is placed under the first threading guide on the spool holder, continue threading through the second and third ribbon guide.
Page 7
Attach the Hoop and Fasten the Holder 1. Slide the embroidery hoop into the hoop attach- ment from front to back until it clicks into place. 2. Touch “OK” to confirm. 3. Remove the presser foot and the presser foot ankle.
Page 8
Attach the Embellishment Attachment When reaching an embellishment block in a design, the presser foot and needle will automatically be set into correct position. (The presser foot should be raised to “up position” and the needle raised to its highest.) Tilt the Embellishment Attachment and insert it from behind carefully.
Page 9
Start your Embroidery: Ribbon This section describes how to start your embroidery with ribbons. For instructions about how to start embroidery with yarn or beads, see next page. Find the Ribbon embroidery tutorial in the “Embellishment At- tachment” or “Embroidery Accessories” sections. 1.
Page 10
Start your Embroidery: Yarn or String of Beads This section describes how to start embroider with yarn or string of beads. Note that the images only show string of beads. The process is similar for yarn (see previous page). Find Yarn and String of Beads embroidery tutorials in the “Embellishment Attachment”...
Page 11
Remove the Embellishment Attachment When the embroidery is finished, the attachment and needle will automatically be set into correct position for removal. (The presser foot should be raised to “up position” and the needle raised to its highest.) How to cut and finish off the ends of the embellish- ment, see respective tutorial in your machine.
Tilting the Accessory Tilting the Embellishment Attachment can be useful if you, for example, need to change the needle. Press the release button and slide the Embellishment Attachment backwards halfway until the markings on the holder and attachment line up (1), and it’s possible to tilt.