Entering Further Sealing Parameters - Pfaff 8390 Instruction Manual

10

Entering further sealing parameters

.03.05
Further sealing parameters can be entered either
● from the manual resp. dynamic sealing mode in conjunction with the sealing speed input
or
● when creating programs in conjunction with the input of the fi rst zone.
● Select acceleration and brake profi le of the feed rollers, dependent on the material for
sealing. Each of the profi les selected is displayed as an inverse symbol. A fl at ramp
stands for slight acceleration of the feed rollers. The selection of a steep ramp means
high acceleration.
Input from manual
heat sealing mode
If the sealing result is unsatisfactory, the alteration of the acceleration or brake
profi le can lead to an improvement.
The values of the different acceleration and brake profi les can be stipulated in
the input mode, see Chapter 11.03.01 Feed roller parameters.
Heat sealing
Input while
creating programs
with PFAFF 8390-010
Example 1
Input while
creating programs
with PFAFF 8390-020
49