Table of Contents
Advertisement
15
Adjustment
15
Notes on adjustment
.01
All adjustments in this manual are based on a fully assembled machine and may only be car-
ried out by technical staff trained for this purpose. Machine covers, which have to be re-
moved and replaced to carry out checks and adjustments, are not mentioned in the text. The
order of the following chapters corresponds to the most logical work sequence for machines
that have to be completely adjusted. Both the preceding and following chapters must be ob-
served if only specific individual work steps are carried out. Screws and nuts indicated in
brackets ( ) are fastenings for machine parts, which must be loosened before any adjustment
and tightened again afterwards.
15
Tools, gauges and other accessories
.02
O 1 set of screwdrivers with knife widths of 2 to 10 mm
O 1 set of wrenches with jaw widths from 7 to 14 mm
O 1 set of Allen keys of 1.5 to 6 mm
O 1 feed dog setting gauge (order no. 61-111 639-71)
O 1 setting gauge (order no. 61-111 639-73)
O 1 adjustment pin (5 mm diameter), order no. 13-033 346-05
O 1 metal ruler (order no. 08-880 218-00)
O Thread and testing material
15
Abbreviations
.03
t.d.c. = top dead centre
b.d.c. = bottom dead centre
15
Explanation of symbols
.04
Activities to be performed or important information in this adjustment manual are empha-
sised by symbols. The symbols used have the following meaning:
Observe and comply with all instructions in the operating manual's chapter 1
Safety! In particular make sure that all safety covers are installed again correct-
ly after making adjustments, see chapter 1.06 Operating manual hazard infor-
mation!
Unless otherwise stated, the machine must be disconnected from the power
supply before all adjustment work!
Risk of injury due to accidental machine start-up!
No screw clamp may be fastened to the needle bar with the PFAFF
2483-980/33!
This may damage the special needle bar coating.
Note, information
Maintenance, repairs, adjustment, service work
(only to be carried out by technical staff)
Adjustment
5
Advertisement
Table of Contents
