Setting The Paper Size - GRAPHTEC MP303-04 User Manual

2.2 Setting the Paper Size

Set the paper size to match the plotting medium to be used.
(1) Press the M O D E key and then press the
(2) Press the ENTER key to display the command selection menu (the currently selected command mode
appears).
(3) Press the or
example, ISO A3).
(4) Each time the or
bits which affect the paper size setting blink).
(5) When the desired size is displayed, press the ENTER key. The prompt below appears.
(6) If the setting is correct, press the E N T E R key. Pressing the key resets the plotter to allow your new setting
to take effect.
To cancel the setting and return to Step (1), press the C A N C EL key.
Setup
DipSW.
（command mode）
key to display the paper size menu and the currently selected paper size (in this
I S O A 3
key is pressed, the paper size setting changes in the sequence shown below (the
ANSI B
ISO A4
Expand
Reset?
ENTorCAN
Ready Ready
or key to display the message below.
X=
or
Y=
2-3