Fuse Replacement; Vehicle - Western HTS Owner's Manual

FUSE REPLACEMENT

The vehicle control harness contains two
automotive blade-style fuses. The snowplow
park/turn power and control power are covered
by individual 10-amp fuses. The control fuse is
"hot" when the vehicle ignition switch is ON and
the electrical connections to the snowplow are
completed.
See the Harness Diagram at the end of this
manual for fuse locations.
The MVP PLUS™ hydraulic unit harness system
contains four automotive blade-style mini fuses.
The 3-solenoid harness (to Port B on the hydraulic
unit module) and 8-solenoid harness (to Port C)
each contain two 4-amp mini fuses.
The WIDE-OUT™ hydraulic unit harness system
contains four automotive blade-style mini fuses.
Lit. No. 49513, Rev. 00
MAINTENANCE
The 2-solenoid harness (to Port B on the hydraulic
unit module) and 6-solenoid harness (to Port C)
each contain two 4-amp mini fuses.
The straight blade and HTS™ hydraulic unit
harness systems contain two 4-amp automotive
blade-style mini fuses in the 3-solenoid harness
(to Port B on the hydraulic unit module).
If a problem should occur and fuse replacement
is necessary, the replacement fuse must be of the
same type and amperage rating as the original.
Installing a fuse with a higher rating can damage
the system and could start a fi re.

VEHICLE

The snowplow operating vehicle shall be
maintained according to manufacturer's
recommendations. Tire pressure shall be
maintained according to manufacturer's
recommendation.
100 August 15, 2011