Western HTS Owner's Manual page 87

6. Select the hole in the rear of the T-frame that
is best aligned with the rear hole in the push
beam and reinstall the rear fasteners. Tighten
all four fasteners to 250 ft-lb.
Select the hole
best aligned with
the rear holes in
the push assembly
Lit. No. 49513, Rev. 00
MAINTENANCE
7. Raise and lower the blade several times. The
cutting edge should be contacting the level
surface across the full length of the cutting
edge.
8. Verify that the cutting edges remain in full
contact with the ground while the wings
are shifted from the scoop position to the
retracted (vee) position. Reinstall blade shoes
if removed in Step 3.
Complete this procedure as often as required
to provide even cutting edge wear. Replace the
cutting edge(s) on your MVP PLUS™ blade when
worn to within 1" of the carriage bolts.
88 August 15, 2011