Western HTS Owner's Manual page 33

Automatic Shutdown
The control will automatically turn OFF after being
idle for 20 minutes. To reactivate the control after
a shutdown, press the ON/OFF button.
Smooth Stop
The control automatically allows the blade to coast
to a stop when the button is released. This results
in smoother operation, reduces the shock to the
hydraulic system and increases hose and valve
life. See "FLEET FLEX Electrical System" in this
section for more information.
Control Functions
Raise, Lower, Float, Angle
The four diamond-shaped buttons in the center of
the control face, when pressed, will result in the
blade movements described in the table.
Lit. No. 49513, Rev. 00
OPERATING YOUR SNOWPLOW
Function Description of Operation
Press this button to raise the snowplow
RAISE and cancel the FLOAT mode. Function
times out after 3.5 seconds.
Press this button to lower the snowplow.
LOWER Release the button to stop blade at
desired height.
Press the LOWER button and hold
3/4 second to activate this mode. The
FLOAT light in the upper left corner of the
control face will illuminate. The blade will
lower to the ground surface and follow the
contour of the surface as it dips or raises.
FLOAT
†
Function does not time out, but control
will shut down after 20 minutes of nonuse.
Press RAISE button momentarily to
cancel FLOAT. Angling left or right will not
interrupt (stop) the FLOAT function.
† FLOAT mode activates immediately when one-touch FLOAT
feature is enabled. See "One-Touch FLOAT" in this section
for more information.
34 August 15, 2011