Western HTS Owner's Manual page 31

1. After seating snowplow horns in receiver
brackets, pull handle up; shoe will lift off the
ground.
ON
Handle
2. Pull and hold lock pin out; then rotate handle
UP and release lock pin. It must lock into
UPPER hole. Stand hook must grip receiver
pin.
Lit. No. 49513, Rev. 00
MOUNTING SNOWPLOW TO VEHICLE
Shoe
ON
(Pull)
Lock Pin
3. Repeat Steps 1 and 2 on other side of
snowplow. (Not required for HTS™ blades.)
4. Connect electrical plugs.
32
Handle
Stand Hook
Receiver Pin
August 15, 2011