Western HTS Owner's Manual page 63

Adjustment Procedure
1. Raise the blade 1' off the road surface, turn
the control OFF, and from in front of the blade,
place jack stands or sturdy blocking under the
cutting edge.
2. Turn the control ON and lower the blade onto
the jack stands or blocking. Turn the control
and vehicle ignition OFF.
3. Remove the linchpin, and slide the disc
shoe down and out of the shoe hole (straight
blades) or shoe holder (MVP PLUS™ and
WIDE-OUT™ blades).
4. Remove one or more washers from the shoe
stem, and reinstall the shoe into the shoe
hole/holder.
Lit. No. 49513, Rev. 00
OPERATING YOUR SNOWPLOW
5. Place the removed washers onto the shoe
stem above the shoe hole/holder.
6. Reinstall the linchpin.
7. Turn the vehicle ignition to the "ON" position,
and turn the control ON. Raise the blade
slightly from the jack stands. Turn the control
OFF, and remove the jack stands.
8. Stand 8' clear of the blade drop zone when
checking the height adjustment of the cutting
edge to the road surface.
64 August 15, 2011